ELECTRONIC NOSES APPLICATIONS AND TECHNOLOGIES
Assessment of fish freshness with an electronic noseRodríguez, D.F.1; Reich, S.2*; Alonso, P3; Szudruk, M.4; Arrieta, C.5; Lacomi, H.5; Gillari, C.5 ; Boselli, A.1; Lamagna, A.1,2
1UAF, Centro Atómico Constituyentes, CNEA, 2Escuela de Ciencia y Tecnología, UNSAM, 3Investigador Independiente, 4Facultad de Ciencias Exactas, UBA, 5Dpto. Microelectrónica, CITEFA, Buenos Aires, Fax: +54 11 6772 7121, *E-Mail: silreich@cnea.gov.ar
Received November 05, 2004. In final form June 04, 2005
Abstract
In this work the performance of a prototype of electronic nose, developed
in our laboratories, to assess fish freshness is analized. The present study
is part of an ongoing project to perform quality assurance protocols for
the Argentine fish sector, an increasing demand due to export reasons and
new national food control regulations. Fish quality is a complex concept
involving a whole range of factors, freshness being one of the most important.
The complete quality assessment of fish meat includes information and control
of all the steps, from catching area to final consumption. In this work we
address one aspect, quality deterioration of “raw fillets” due
to frozen storage defects.
Resumen
En este trabajo se analiza el desempeño de un prototipo de nariz electrónica,
desarrollado en nuestros laboratorios para detectar el grado de conservación
de la carne de pescado. El presente estudio es parte de un proyecto en marcha
para crear protocolos para el control de calidad en el sector pesquero argentino,
una creciente demanda debido a razones de exportación y a nuevas regulaciones
locales de control vigentes. La calidad de la carne de pescado es un concepto
complejo que incluye información y control de todas las etapas, desde la
zona de pesca hasta su consumo final. En este trabajo tomamos sólo un
aspecto, el deterioro de la calidad de carne de filetes crudos debido a fallas
en el almacenamiento refrigerado.
Introduction
Control of fish freshness is of great economic relevance, as the Argentine hake is one
of the most important fishes consumed. Quality assurance of raw fillets involves
monitoring and documenting defined quality criteria as required by regulations.
These requirements may be of different importance to the various parts of the
supply and distribution chains.
During fish chilled storage, biochemical changes are known to take place, such
as changes in the protein and lipid fractions and the formation of amines (volatile
and biogenic) and hypoxanthine. As a consequence of these events, a deterioration
in sensory quality, a loss of nutritional value and negative modifications of
the physical properties of fish muscles may be expected [1]. Consequently, the
time passed after catch and the temperature ‘history’ of fish is
very often the key factor determining the final quality of a fish product.
Transport and storage under constant temperature conditions are supposed to
be always fulfilled everywhere and thus it is generally assumed that the only
relevant factor is the number of storage days. However the chilled chain may
have been interrupted for some reasons and thus the spoiling process is accelerated.
This is the motivation of the present work. That is to find a method for detecting
abnormalities in the chilled process. Electronic noses have proved [2] to be
a suitable instrument for this task.
Figure 1.
Experimental
Spoilage
odours, that develop as a result of microbial growth and oxidation leading to
the degradation of the tissue, are sensed by an electronic nose prototype, PampaNose
2, developed in our laboratories [3] and shown in Figure 1.
The sensor array is composed by six micromachined SnO2 sensors (low
power consumption, below 50mW). Distinct electric behavior of the corresponding
sensitive film is achieved through doping some of these sensors with Au and
others with tetra t-Butyl Zinc Phthalocyanine. Two commercial sensors, for temperature
and relative humidity control, are included inside the sensor chamber, meant
keep track of these important parameters during the measurements. The electronic
interface sets the temperature of the sensing film and controls the sampling
and acquisition of the different signals from each sensor resistance when a
given gaseous sample is present. The SnO2 thin films for the gas-sensor
devices were done using the RGTO (Rheotaxial Growth and Thermal Oxidation) technique
on a substrate heater element made on micro machined silicon and having a 200
nm Si3N4, membrane as a physical support of the entire
sensor stack (microhot plates) [4, 5].
This micro hot plates for this work were provided by CNR-IMM Bologna, Italy.
The sensor active layer of SnO2 film was selectively deposited on
the central part of the membrane by means of a shadow mask. During the deposition,
substrates were heated at 420 °C in high vacuum. After the thermal oxidation
process, the SnO2 thickness is 200 nm.
Microscopic analysis showed the thin films were polycrystalline, with nano-structured
grains, of high porosity and high specific surface area. This particular morphology
exhibits a high film porosity and specific surface area, which are optimum prerequisites
for sensors applications.
Fillets corresponding to the same catching area and catching date were analyzed.
Samples of fresh hake were kept inside a freezer at -20 °C in closed containers.
All the samples were analyzed three days after, during the first day they were
taken out of the freezer and kept at ambient temperature for a given number
of hours, and then taken back to the freezer.
For each measurement, 40 grams of raw fillet were taken from the refrigerator
and put inside 250 cm3 glass bottles. The bottles were sealed and
held at room temperature (20°C±2°C) for 20 minutes in order to
reach a stable headspace composition.
The headspace was then fluxed into the e-nose sensor chamber at a flow of 200
ml/min. The nose response was registered each 0.5 minutes for a time interval
of approximately 5 minutes and after that, a 10 minutes purge was done. Ambient
air was used as the carrier gas. The sampled headspace and the carrier were
alternately switched by a three-way valve according to this time schedule.
Results and discussion
We analyzed interruptions from the storage temperature of 3 hours, 6 hours and
24 hours, in addition to the reference samples with the same number of storage
days but no freezing interruption. For each sensor signal we take only one feature,
the relative normalized peak value with respect to the carrier line base. It
was established elsewhere [6] that no significant improvement may be expected
if more features for each sensor signal are taken into account with this nose.
For validation purposes we left aside some of the measured samples (two for
each time period at ambient air), before freezing. Within this restricted space
we performed an unsupervised PCA analysis. We check the performance of the PCA
analysis with and without normalization of the data set. That is to say, we
performed PCA using the covariance matrix (unnormalized variables) and the correlation
matrix (normalized variables). The results for the case of the covariance matrix
implies that the first principal component takes into account a combination
of only two sensors which not only displays the greater signals but also the
largest variance between the different nose responses. Use of the covariance
matrix, takes into account a combination of all sensor responses for the first
principal components plus that of one sensor that shows no significant signal
for all the measurements.
Once the classes get self organized in rather well distinguished regions, we
discard outliers and validate the classification scheme using the rest of the
data that was not processed. For each measurement we project the nose response
onto the already defined score plane and assigned the nearest class to its corresponding
transformed point. We choose to consider the distance within the PCA space approximating
each cluster and thus classes were assigned taken into account the smallest
residual. We obtained eight patterns out of eight correctly classified. This
approach, although for only two significant principal components, is similar
to SIMCA [7]. All these results are sumarized in Figure 2
and Figure 3.
The analysis show that the electronic nose detects departures from fish freshness
due to interruptions in the chilled chain. There seems to be three different
regions. One for fresh or up to one hour interruption in the freezing storage,
other for intermediate periods between 3 to 6 hours, and a third region where
samples have been left at ambient temperature for almost one day.
Although discrimination is obtained with both methods, PCA with covariance matrix
gives the best results. The method is equivalent to take into account only the
most significant sensors (two out of six). Larger distances are observed between
clusters compared with the use of the correlation matrix PCA.
Fig.
2. Principal Component analysis of hake fillets samples with different storages
times with the use of covariance matrix. In all cases empty symbols refer to
the location of data used for validation.
Fig.3.
Principal Component analysis of fillets samples with different storages times
with the use of correlation matrix. In all cases empty symbols refer to the
location of data used for validation.
Conclusions
This
is a first analysis that shows the ability of an electronic nose to detect abnormalities
in the temperature history during storage. The information needs to be complemented
with other biochemical studies and also with panel evaluation to analize the
significance of the observed departures from the reference fillet. A similar
study for different storage days is in progress.
Acknowledgments
The authors wish to acknowledge support from IMM-CNR, Bologna
section and financial support of J.P.A. S.A. (Javier Picco y Asoc.) through
grant PID131-2001 of the National Agency for the Promotion of Science and Technology
(ANPCYT) of Argentina.
References
[1] Hsieh R.; Kinsella J., Advances in Food Research and Nutrition Research 1989, 33, 233–341.
[2] Di Natale C.; Bruinink J.; Bungaro F.; David F.; d’Amico A.; Paolesse R.; Boschi T., Faccio M.; Ferri G., Sci. Technol. 1996, 7, 1103–1114.
[3] Lamagna A.; Reich S.; Negri M.; Boselli A.; Cocco M.; Di Natale C., Thin Solid Films, 2002, 418, 42-44.
[4] Sberviglieri G.; Faglia G.; Groppelli S.; Nelli P.; Camazzi A., Semicon. Sci. Technol. 1990, 5, 1231.
[5] Briand D.; Krauss A.; Van der Schoot B.; Weimar U.; Barsan N.; Gopel W.; de Rooij N.F., Sensors & Actuators B , 2000, 68, 223-233.
[6] Lamagna A.; Reich S.; Rodriguez D.; Scoccola N.N., Sensors & Actuators B, 2004, 102, 278-283.
[7] Wold, S., Pattern Recognit. 1976, 8, 127- 141.