Resumo

FERREIRA-BARBOSA, Isabel et al. Effect of alternative solvent evaporation techniques on mechanical properties of primer–adhesive mixtures. Acta odontol. latinoam. [online]. 2020, vol.33, n.2, pp.135-142.  Epub 01-Set-2020. ISSN 0326-4815.

This study evaluated the influence of the mode and time of solvent evaporation on the tensile strength (TS), flexural strength (FS) and elastic modulus (EM) of two adhesive systems: Scotchbond Multipurpose (SBMP) and Clearfil SE (CSEB). For this purpose, rectangular samples (2x1x7 mm) were prepared with 10 μL of primer and the solvents were evaporated with air spray at (23±1) ºC, (40±1) ºC and negative control (without spray). For each temperature, the times of 5, 20, 30, and 60 seconds were investigated. The statistical results showed that evaporation at 40±1ºC resulted in better EM for the two adhesives tested and all the evaporation times evaluated. However, there were no significant differences between the times and modes of evaporation for TS. The results of this study indicate that evaporation at a temperature of (40±1) °C could improve the elastic modulus of both adhesives tested, regardless of the evaporating time.

Palavras-chave : Dentin bonding agents; Tensile strength; Flexural strength.

        · resumo em Português     · texto em Inglês     · Inglês ( pdf )